| Driving Type: | AC Elevator |
|---|---|
| Capacity: | <500kg |
| Persons: | <5 |
Suppliers with verified business licenses
Audited Supplier Audited by an independent third-party inspection agency
| Load capacity(KG) |
Speed(m/s) | Door opening size(mm) |
Car size(mm) (Width x Depth) |
Shaft size(mm) (Width x Depth) |
Overhead height(mm) | Pit depth(mm) |
| 250 |
0.4 | 600*2000 | 950*1000 | 1600*1350 | 3600 | 650 |
| 320 |
0.4 | 700*2000 | 1000*1000 | 1750*1400 | 3600 | 650 |
| 400 |
0.4 | 700*2000 | 1050*1100 | 1700*1450 | 3600 | 650 |
| Safety function |
Photocell protection | In the door open and shut period, infrared light that covers the whole door height is used to probe the door protection device of both the passengers and objects. |
| Designated stop | If the elevator can not open the door in the destination floor out of some reason, the elevator will close the door and travel to the next designated floor. | |
| Overload holding stop | When the car is overload, the buzzer rings and stops the elevator in the same floor. | |
| Anti-stall timer protection | The elevator stops operation due to slippery traction wire rope. | |
| Start protection control | If the elevator does not leave door zone with in the designated time after it gets started, it will stop the operation. | |
| Inspection operation | When the elevator enters into inspection operation, the car travels at inching running. | |
| Fault self-diagnosis | The controller can record 62 latest troubles so as to quickly remove the trouble and restore the elevator operation. | |
| Repeated door closing | If the elevator can not close the door due to certain obstacle or interference, the elevator will reopen or re-shut the door until sundries are eliminated. | |
| Up/down over-run and final limit protection | The device can effectively prevent the elevator from surging to the top or knocking the bottom when it is out of control. It results in more safe and reliable elevator travel. | |
| Down over-speed protection device | When the elevator downs 1.3 times higher than the rated speed, this device will automatically cut off control mains, stop the motor running. Safety tongs act to force the elevator stop in order to ensure the safety. | |
| Upward over-speed protection device | When the elevator up speed is 1.3 times higher than rated speed, the device will automatically decelerate or brake the elevator. |
| Man-computer interface | Micro-touch button for car call and hall call | Novel micro-touch button is used for operation panel command button in the car and landing calling button. |
| Floor and direction indicator inside car | The car shows the elevator floor location and current travel direction. | |
| Floor and direction indicator in hall | The landing shows the elevator floor location and current travel direction. |
| Emergency function |
Emergency car lighting | Emergency car lighting automatically activated once power failure. |
| Inching running | When the elevator enters into emergency electric operation, the car travels at low speed inching running. | |
| Five way intercom | Communication amid car, car top, elevator machine room, well pit and rescue duty room through interphone. | |
| Bell | In emergency conditions, if bell button above car operation panel is continuously pressed, electric bell on top of the car will ring . | |
| Fire emergency return | If you start key switch in main landing or monitor screen, all the callings will be canceled. The elevator directly and immediately drive to the designated rescue floor and automatically open the door. |
| Energy-saving function | Car ventilation, automatic lighting switch | If there is no calling or command signal within the stipulated time, the car fan and lighting will be automatically closed in order to save energy. |
| Remote shut-off | The elevator can be called to main landing(after finishing the service) through the key switch and automatically exists the service. |
){kind=link}